|
|
Post by mulchlady on Jan 13, 2012 8:23:34 GMT -5
I am sure this has been asked before and I missed the answer because I didn't have a vagabond at the time. How do you keep the plates from warping?
|
|
|
|
Post by AnnaMatrix on Jan 13, 2012 10:38:16 GMT -5
They eventually will warp, but I flip them over and front to back to try to get them to "wear" evenly. Trying to place dies towards the end of the plates and not always dead center helps, too. My system is to put a brand new plate underneath the die, and use the same top "cutting plate" over and over until it gets too warped or cut up, then I move the bottom plate to the top, and put a new plate underneath. These plates are the same ones used in the Big Shot, so they're usually pretty easy to find. I stock up when they're on sale, so I always have back-ups on hand. HTH.  Gail |
|
|
|
Post by mulchlady on Jan 13, 2012 11:57:10 GMT -5
Good ideas! Thanks! I will have to stock up on the plates too.
|
|
